Court Hardware Setup
Your court is anchored, aligned, and ready to play, hoops, nets, posts, and padding all checked before sign-off.
What Goes Wrong
Most accessory problems trace back to one skipped step, here is where they start and how the right approach stops them.
Installing new hardware over corroded sleeves or cracked anchor bolt holes transfers the original instability directly to the new equipment.
Every existing sleeve and bolt hole is inspected before positioning new hardware, with replacements scoped in the written estimate.
A hoop or net post set even two degrees off plumb affects ball trajectory and net tension, and the error compounds with every use.
Each post and hoop is set to a verified plumb line and level tolerance before anchor bolts are torqued to the specified depth.
Accessories sized or anchored for one surface type, asphalt versus modular tile, shift, loosen, or crack the surface around the mount point.
Anchor bolt depth and bracket gauge are selected for the specific surface material, whether asphalt, concrete, or modular tile.
A loose post or rusted bracket left in place continues to work the anchor hole wider, turning a simple hardware swap into a surface repair job.
Worn or corroded hardware is identified at the initial site assessment so replacements are included in the estimate before work begins.
What We Cover
From a single hoop mount to a full pickleball net system, every accessory type follows the same anchoring and alignment process.
In-ground post anchoring to specified depth, bracket mounting, and a level check on the backboard and rim before sign-off.
Net post anchoring, net tensioning hardware set to regulation 36-inch center height, and a stability check on both post sleeves.
Post placement, anchor bolt securing, and net tensioning set to the 34-inch center regulation height for singles or doubles play.
Rubber base padding and pole guard placement around posts and fencing uprights to meet safety clearance requirements.
Bracket and tension-wire attachment to existing fence posts, checked for alignment with the court boundary line.
Removal of corroded or stripped anchor sleeves, surface repair around the bolt hole, and installation of new hardware to spec.
Steel sleeves set to surface-specific anchor depth.
Bracket selection matched to post gauge and surface type.
Tensioners set and checked against regulation net height.
Padding fitted around poles and fencing uprights.
Why Choose Us
Every enquiry is handled the same way: an on-site evaluation first, a written estimate second, and a final walkthrough before the project closes.
A visit to the court checks anchor condition, and the estimate is written from what is actually there, not a phone description.
The estimate lists materials, hardware scope, and any anchor or surface repairs as separate line items, no lump-sum surprises.
We scope your project. The written estimate names who carries out the work, so you know who is accountable for the result.
The project does not close until a walkthrough confirms every anchor, bracket, and net tensioner has been physically checked.
Basketball, tennis, pickleball, and multi-use courts are all within scope, the install method is matched to the court and equipment type.
The Process
01
Tell us the court type, the accessories needed, and any existing hardware issues so we can scope the right evaluation.
02
A visit assesses anchor points and surface condition, then provides an itemized written estimate covering all hardware and scope.
03
The builder installs, anchors, and levels every accessory, then carries out a physical check of each mount point before sign-off.
Pricing Estimates
| Job | Typical cost |
|---|---|
| Net or post installation | $250-$700 |
| Fence or divider accessory | $500-$1,500 |
| Court lighting accessory install | $1,500-$4,000 |
Describe your site and we will schedule an on-site evaluation and an itemized written estimate.