Surface Renewal
Restore an even, consistent playing surface, no more ponding water, rough spots, or faded lines.
What Goes Wrong
Skipping steps in the resurfacing sequence creates problems that compound with every season.
Applying acrylic coating over unrepaired cracks seals moisture in; freeze-thaw cycles reopen the crack wider than before.
Every crack is filled and patched before coating begins, removing the entry point for water and sub-base movement.
Low spots left before coating lock in drainage problems, producing ponding water and uneven bounce that worsen each year.
Surface leveling corrects low spots and restores the drainage gradient before any acrylic layer is applied.
Applying the second acrylic layer before the first has cured causes delamination, peeling, and a shortened surface life.
The local builder observes manufacturer recoat intervals between layers so each coat bonds fully to the one below.
Patching isolated areas when wear is spread across the court leaves mismatched surfaces with inconsistent ball response.
The on-site base assessment confirms whether targeted patching holds or a full resurfacing sequence is the right call.
Scope of Work
The full resurfacing sequence addresses every layer from base assessment through to regulation line restriping.
Crack width, pattern, and base stability are evaluated to confirm whether patching or full resurfacing is needed.
Hairline and structural cracks are filled with compatible patch material before any coating work begins.
Low spots are built up to restore the correct drainage gradient and eliminate ponding water across the court.
Two acrylic coating layers are applied over sealcoat with recoat intervals observed between each pass.
Court lines are repainted to regulation dimensions once the final coating layer has fully cured.
Damaged edges and heavily worn zones are addressed as part of the overall surface restoration sequence.
Full resurfacing sequence for residential asphalt courts.
Surface restoration for school, park, and community courts.
Resurfacing for rental and commercial property courts.
Why Choose Us
Every resurfacing enquiry is handled with the same structured process, on-site evaluation, itemised estimate, and a final walkthrough before the project closes.
The local builder documents crack pattern, slope, and drainage before writing a single number on the estimate.
Crack repair, leveling, coating, and restriping are listed as separate line items with materials and cure times.
We arrange on-site evaluations and resurfacing work through local court builders nationwide, not a remote call center.
Lines, surface finish, and drainage are reviewed at a final walkthrough before the project is formally closed.
We handle enquiries for residential backyard courts, school courts, and community or commercial property courts.
The Process
01
Tell us the court size, visible damage, and location so we can arrange the right local builder for your site.
02
The local builder inspects base condition, drainage, and crack pattern, then provides an itemised written estimate.
03
The builder completes crack repair, leveling, coating, and restriping, then walks the finished surface with you.
Pricing Estimates
| Job | Typical cost |
|---|---|
| Small asphalt court resurfacing | $3,500-$8,000 |
| Standard asphalt court resurfacing | $7,500-$16,000 |
| Large asphalt court resurfacing | $16,000-$30,000 |
Describe your site and we’ll arrange an on-site evaluation and itemised written estimate from a local court builder.